Uniden MHS135DSC English Owner's Manual - Page 15

setting UP YOUr raDiO

Get Uniden MHS135DSC PDF manuals and user guides View all Uniden MHS135DSC manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

4. Insert the two hooks on the lower part of the case into the notches on the cover; close the cover. (The cover fits snugly but you should not have to force it closed.) NOTE: Each time you open the battery case, check the rubber seal. Make sure the seal is seated in the groove and there is no dirt or debris on it. If the rubber seal looks worn or damaged, contact customer service to order a replacement (see the back cover page for contact information). 5. Install the alkaline battery case in your radio just as you do the Li-Ion battery (see page E-10). WARNING! The case is designed to prevent the accidental charging of alkaline batteries. Never use alkaline batteries in the radio without the battery case. Do not attempt to modify the battery case design. Mounting the Charger You can mount the charger on any flat surface. 1. Use the two holes at the base of the charger as a template to mark the drill holes. 2. Using a 1/8-inch (or 3 mm) drill bit, drill two holes 1/2 inch (13mm) deep. 3. Use the provided screws to attach the charger to the surface. Charging the Battery Your radio includes a charger and a rechargeable battery pack. Place your radio in the charger with the display facing forward. Make sure that the CHARGE LED on the charger turns orange. Cautions: xx Use only the battery and charger supplied with this radio. Using a different charger or battery can damage the radio and create a risk of fire or shock. xx The charger is not waterproof. If the charger falls into the water, unplug it before attempting to remove it from the water. After you remove the charger from the water, please contact Customer Service (see the back cover page for contact information). xx Wipe off dirt or shake water from your radio before placing in the charger if your radio gets dirty or wet. Important notes on charging the battery xx Charge the battery fully before using the radio. xx Don't use the charger when the ambient temperature is below 0° C (32° F) or above 45° C (113° F). xx If the radio is powered down, the battery can charge in about seven hours. (If the radio is powered on, the battery takes longer to charge.) Setting Up Your Radio Turning It On Press the POWER button for at least two seconds to turn the radio on. Press and hold it to turn the unit off. Uniden MHS135DSC Radio Owner's Manual E-11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
E-11
Uniden MHS135DSC Radio Owner’s Manual
4.
Insert the two hooks on the lower part of the case into the notches on the cover;
close the cover. (The cover fits snugly but you should not have to force it closed.)
nOte:
eAch °mE you opEN ThE bA±ERy cASE, chEcK ThE RubbER SEAL. MAKE SuRE ThE SEAL
IS SEATEd IN ThE GRoovE ANd ThERE IS No dIRT oR dEbRIS oN IT. if ThE RubbER SEAL LooKS woRN
oR dAmAGEd, coNTAcT cuSTomER SERvIcE To oRdER A REpLAcEmENT (SEE ThE bAcK covER pAGE
foR coNTAcT INfoRmA°oN).
5.
Install the alkaline battery case in your radio just as you do the Li-Ion battery (see
page E-10).
Warning!
thE cASE IS dESIGNEd To pREvENT ThE AccIdENTAL chARGING of ALKALINE bA±ERIES.
nEvER uSE ALKALINE bA±ERIES IN ThE RAdIo wIThouT ThE bA±ERy cASE. Do NoT A±EmpT To
modIfy ThE bA±ERy cASE dESIGN.
MOUnting tHe CHarger
You can mount the charger on any flat surface.
1.
Use the two holes at the base of the charger as a template to mark the drill holes.
2.
Using a 1/8-inch (or 3 mm) drill bit, drill two holes 1/2 inch (13mm) deep.
3.
Use the provided screws to attach the charger to the surface.
CHarging tHe BatterY
Your radio includes a charger and a rechargeable battery pack.
Place your radio in the charger with the display facing forward.
Make sure that the CHARGE LED on the charger turns orange.
CAu°oNS:
x
Use only the battery and charger supplied with this radio. Using a different
charger or battery can damage the radio and create a risk of fire or shock.
x
The charger is not waterproof. If the charger falls into the water, unplug it
before attempting to remove it from the water. After you remove the charger
from the water, please contact Customer Service (see the back cover page
for contact information).
x
Wipe off dirt or shake water from your radio before placing in the charger if
your radio gets dirty or wet.
Important notes on charging the ba°ery
x
Charge the battery fully before using the radio.
x
Don’t use the charger when the ambient temperature is below 0° C (32° F) or
above 45° C (113° F).
x
If the radio is powered down, the battery can charge in about seven hours. (If the
radio is powered on, the battery takes longer to charge.)
setting UP YOUr raDiO
tUrning it On
Press the
POWER
button for at least two seconds to turn the radio on. Press and hold it
to turn the unit off.