Uniden TRU8888 English Owners Manual - Page 58

Turning the Answering System On/Off THE INTEGRATED ANSWERING DEVICE note •When the answering system is full, you will hear "No Remaining Time" and (7.. appears on the LCD. You should delete some messages so that the system can record new messages. •Position yourself as near to the base as possible and speak clearly when recording your outgoing message. •If you make an outside call or a call is received during the operation, the operation is canceled. 1) To turn the answering system on, press answer on/ off on the base when the phone is in standby mode. /'55#)' and the number of messages stored in memory appears on the LCD. If the LCD flashes, then there are new messages waiting for you. 2) To turn the answering system off, press answer on/ off on the base. #059'4 1(( appears on the LCD. Setting Your Outgoing Message (Greeting) When you receive a call, the answering system automatically plays either the prerecorded message or your own greeting. To record your own greeting, or choose between the two outgoing messages, refer to "Answering System Setup" on page 53. The following message is pre-recorded: "Hello, no one is available to take your call. Please leave a message after the tone." Announce only feature The announce only feature plays a pre-recorded outgoing message or your own personal outgoing message, but it will not allow the caller to leave a message. To set announce only, follow the steps on "Setting the Record Time" page 55. If you want to use your own greeting and you want to change your greeting to omit the prompt to leave a message, refer to "Selecting Your Greeting (Base only)" on page 53. The following message is pre-recorded: "Hello, no one is available to take your call. Please call again." [57] THE INTEGRATED ANSWERING DEVICE www.uniden.com