ViewSonic PJ502 User Manual - Page 18

Power on/off WARNING X When the power is on, a strong light is emitted. Do not look into the lens or vents of the projector. NOTE. Turn the power on/off in right order. Please power on the projector before the connected devices. Power off the projector after the connected devices STANDBY / ON button POWER indicator STANDBY / ON button Power switch (On position) (Off position) Turning on the power 1. Make sure that the power cord is firmly and correctly connected to the projector and outlet. 2. Remove the lens cover, and set the power switch to the ON position. The power indicator will light to solid orange. Then wait several seconds because buttons may not function for these several seconds. 3. Press the STANDBY/ON (on the projector or the remote control) button. The projector lamp will light up and the POWER indicator will begin blinking green. When the power is completely on, the indicator will stop blinking light green. To display the picture, select an input signal according to the section "Selecting an input signal". Turning off the power 1. Press the STANDBY/ON (on the projector or the remote control) button. The message "Power off?" will appear on the screen for approximately 5 seconds. 2. Press the STANDBY/ON (on the projector or the remote control) button again while the message is visible. The projector lamp will go off, and the POWER indicator will begin blinking orange. Then the POWER indicator will stop blinking and light to solid orange when the lamp cooling is complete. 3. Make sure that the power indicator lights to solid orange, set the power switch to the OFF position. The POWER indicator will go off. ViewSonic PJ502 15