ViewSonic PJD7822HDL User Guide - Page 43
Using the CEC function
View all ViewSonic PJD7822HDL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
To activate the High Altitude Mode: 1. Press MENU/EXIT on the projector or Menu on the remote control and then press / until the SYSTEM SETTING: ADVANCED menu is highlighted. Notice We recommend you use the High Altitude mode by selecting it whenever your environment is higher than 1500 m. Do you want to turn High Altitude Mode ON? 2. Press to highlight High Altitude Mode and Yes No press / to select On. A confirmation message is displayed. 3. Highlight Yes and press MODE/ENTER on the projector or Enter on the remote control. Operation under "High Altitude Mode" may cause a higher decibel operating noise level because of increased fan speed necessary to improve overall system cooling and performance. If you use this projector under other extreme conditions excluding the above, it may display auto shut-down symptoms, which is designed to protect your projector from over-heating. In cases like this, you should switch to High Altitude Mode to solve these symptoms. However, this is not to state that this projector can operate under any and all harsh or extreme conditions. Using the CEC function This projector supports CEC (Consumer Electronics Control) function for synchronized power on/off operation via HDMI connection. That is, if a device that also supports CEC function is connected to the HDMI input of the projector, when the projector's power is turned off, the power of the connected device will also be turned off automatically. When the power of the connected device is turned on, the projector's power will be turned on automatically. To turn on the CEC function: 1. Press MENU/EXIT on the projector or Menu on the remote control to open the OnScreen Display (OSD) menu. 2. Go to the SYSTEM SETTING: BASIC > CEC menu. 3. Press / to select On. • In order for the CEC function to work properly, make sure that the device is correctly connected to the HDMI input of the projector via a HDMI cable, and its CEC function is turned on. • Depending on the connected device, the CEC function may not work. 36