Viking VISC5304BSS Use and Care Manual - Page 24

Product Care Self-Clean Cycle To start the Self-Clean cycle: 1. Close the door completely. 2. Turn the oven selector knob clockwise to the "SELF CLEAN" mode. 3. Turn the temperature control knob past the clean setting until the knob stops. At this time, the clean indicator light will come on. Within 30 seconds the automatic door latch engages and the oven indicator light comes on. The oven indicator light will remain on until the oven reaches the self-clean temperature and will then cycle on and off during the self-clean cycle. When the oven reaches the elevated temperature needed for self-clean, the door lock indicator light comes on. 4. The door lock indicator light will remain on until the self-clean is completed or interrupted and the oven temperature drops to a safe temperature. A complete cycle is approximately 3-1/2 hours with an additional 30 minutes needed for the oven to cool down enough for the door latch to disengage. Note: A fan noise will be heard during the self-clean cycle and will continue to run for the 3-1/2 hour duration of the self-clean cycle. 5. When the cycle is completed, turn both the oven selector and temperature control knob to the "OFF" position. When the oven has completely cooled, open door and remove any ash from the oven surfaces with a damp cloth. To stop the Self-Clean cycle: To cancel or interrupt the self-cleaning cycle, turn both the temperature control knob and the oven function selector knob to "OFF". When the oven temperature drops to a safe temperature, the automatic door latch will release and the oven door can be opened. When the oven has completely cooled, remove any ash from the oven surfaces with a damp sponge or cloth. 46 Replacing ODvAeNnGLEigRhts WARNING ELECTRICAL SHOCK HAZARD Disconnect the electric power at the main fuse or circuit breaker before replacing bulb. CAUTION To avoid risk of personal injury, DO NOT touch bulb with bare DANGER hands. Clean off any signs of oil from the bulb and handle with a soft cloth. 1. Unsnap glass light cover using a screwdriver in the access groove. glass light cover 2. Firmly grasp light bulb and access groove pull out. 3. Replace with halogen bulb using volt and wattage CAUTION requirements listed on glass light FOR YOUR SAFETY cover. bulb 4. Replace the light cover by snapping glass cover onto metal box. 5. Reconnect power at the main fuse or circuit breaker. FOR YOUR SAFETY 47 Product Care