Weber 3100 NG Owner Manual - Page 11
Step 5, Step 6
View all Weber 3100 NG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Step 4 Continue frame assembly You will need: frame assembly, wheel frame assembly, front panel, caster frame, four 1/4-20 x 1/2 inch bolts, four nylon washers and a 7/16 inch wrench. Place the caster frame onto the tabs of the left frame with the dimple to the inside. Figure 3. Place the wheel frame onto the tabs of the right frame with the dimple to the inside. Figure 3. The leg tabs must be on the inside of the frames. Add front panel with the hole down and to your right. Add the washers to the bolts, insert in the holes as shown. Only start the bolts at the wheel frame, figure 3 (a) & (b), and tighten the bolts at the caster frame. Caster frame Dimples to the inside Step 5 Complete frame assembly You will need: partial frame assembly, two frame connectors, four 1/4-20 x 2 inch bolts, four nylon washers and a 7/16 inch wrench. Hold one frame connector between the caster and wheel frame. Add nylon washers to the bolts. Put the bolts through the frame and screw into frame connector. Tighten. Repeat procedure with the other frame connector. Figure 4. Wheel frame (a) Only start this bolt Figure 3 Figure 4 (b) Step 6 Insert casters You will need: frame assembly and two casters. Push the casters firmly into the inserts in the ends of the caster legs. Figure 5. Figure 5 11