Weider 8920 English Manual - Page 11

19. Slide two Cable Traps (66) and two 90mm 19 Pulleys (15) onto two M10 x 90mm Bolts (16). Insert the Bolts into the Front Upright (42) from the direction shown. Hand tighten an M10 Nylon Locknut (21) with an M10 Washer (9) onto each Bolt. Be sure that all parts are oriented as shown. Do not tighten the Nylon Locknuts yet. 42 9 21 16 66 15 16 15 66 20. Route the Short Cable (23) around the 90mm 20 Pulley (15) attached to the lower hole in the Front Upright (42). See the inset drawing. Be sure that the Cable Trap (66) is turned to hold the Cable in place. Properly tighten the M10 Nylon Locknut (21) and the M10 x 90mm Bolt (16). 21 42 42 15 15 16 23 66 23 Inset shows view from other side 21. Route the Short Cable (23) around the 90mm Pulley (15) attached to the upper hole in the 21 Press Frame (17). Be sure that the Cable Trap (66) is turned to hold the Cable in place. Properly tighten the M10 Nylon Locknut (21) Route the Short Cable (23) around the 90mm Pulley (15) attached to the upper hole in the Front Upright (42). Refer to the inset drawing. Be sure that the Cable Trap (66) is turned to hold the Cable in place. Properly tighten the M10 Nylon Locknut (21) and the M10 x 90mm Bolt (16). 42 15 16 66 23 42 Inset shows view from other side 23 15 15 66 21 21 17 11