Weider 8920 English Manual - Page 18

Trouble-shooting And Maintenance - replacement parts

Get Weider 8920 PDF manuals and user guides View all Weider 8920 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

TROUBLE-SHOOTING AND MAINTENANCE Make sure all parts are properly tightened each time you use the weight system. Replace any worn parts immediately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents. TIGHTENING THE CABLES Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened. Slack can be removed from the Short Cable (23) by by tightening the M8 Nylon Locknut (3) at the end of the Cable. Additional slack can be removed by moving the 90mm Pulley (15) to the other hole in the Long "U"Bracket (57). Remove the M10 Nylon Locknut (21) and the M10 x 45mm Bolt (12) from the Cable Trap (66), the Pulley, and the "U"-Bracket. Re-attach the Pulley and the Cable Trap to the other hole in the "U"Bracket with the Bolt and Nylon Locknut. Make sure that the Cable Trap is in the proper position and that the Cable and Pulley move smoothly. Note: If a cable tends to slip off the pulleys, the cable may have become twisted. Remove the cable and re-install it. If a cable needs to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual. 66 15 57 21 12 3 23 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
18
TROUBLE-SHOOTING AND MAINTENANCE
Make sure all parts are properly tightened each time you use the weight system. Replace any worn parts immedi-
ately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is
slack in the cables before resistance is felt, the cables should be tightened.
Slack can be removed from the Short Cable (23) by
by tightening the M8 Nylon Locknut (3) at the end of
the Cable.
Additional slack can be removed by moving the
90mm Pulley (15) to the other hole in the Long “U”-
Bracket (57). Remove the M10 Nylon Locknut (21)
and the M10 x 45mm Bolt (12) from the Cable Trap
(66), the Pulley, and the “U”-Bracket. Re-attach the
Pulley and the Cable Trap to the other hole in the “U”-
Bracket with the Bolt and Nylon Locknut.
Make sure
that the Cable Trap is in the proper position and
that the Cable and Pulley move smoothly.
Note: If a cable tends to slip off the pulleys, the
cable may have become twisted. Remove the
cable and re-install it. If a cable needs to be
replaced, see ORDERING REPLACEMENT PARTS
on the back cover of this manual.
57
66
15
3
23
12
21