Weider 950 English Manual - Page 11

19. Wrap the Short Cable (80) around a Pulley (39). 19 Attach the Pulley to the Double "U"-Bracket (15) with an M10 x 45mm Bolt (68) and an M10 Nylon Locknut (56). 15 56 80 68 39 20. Attach the Short Cable (80) to the "U"-Bracket 20 (81) with an M8 Washer (76) and an M8 Nylon Locknut (61). Note: Do not completely tighten the Locknut; it should be threaded only two turns onto the end of the Cable, as shown in the inset drawing. 76 80 81 61 80 61 21. Locate the Low Cable (37). Lay the Cable in the 21 bracket on the Base (1) with the ball on the side shown. Attach a Pulley (39) inside the bracket on the Base (1) with an M10 x 45mm Bolt (68) and an M10 Nylon Locknut (56). 22. Route the Low Cable (37) through the hole in the 22 Front Upright (4) and around a Pulley (39). Attach the Pulley and a Cable Trap (41) inside the brack- et on the Upright with an M10 x 48mm Bolt (77) and an M10 Nylon Locknut (56). Be sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley. 39 68 37 56 1 41 77 39 4 56 37 11