Weider 950 English Manual - Page 8

CABLE ASSEMBLY 8 8. Refer to the CABLE DIAGRAM on page 18 for proper cable routing. Locate the High Cable (35). Route the eyelet end of the Cable up through the Top Frame (5) and around a Pulley (39). Attach the Pulley inside the Top Frame with an M10 x 65mm Grade 5 Bolt (73), two M10 Washers (55), two M10 Spacers (74), and an M10 Nylon Locknut (56). 35 5 39 56 74 55 74 55 73 9. Wrap the High Cable (35) around a Pulley (39). 9 Attach the Pulley and a Cable Trap (41) inside the bracket on the Top Frame (5) with an M10 x 48mm Bolt (77) and an M10 Nylon Locknut (56). Be sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley. 39 77 5 41 35 56 10. Route the High Cable (35) down through the Top 10 Frame (5) and around a Pulley (39). Attach the Pulley and a Cable Trap (41) to the second set of holes from the top of the two Pulley Plates (14) with an M10 x 48mm Bolt (77) and an M10 Nylon Locknut (56). Be sure the Cable Trap is turned to hold the Cable in the groove of the Pulley. 8 5 35 39 41 56 77 14