Weider 950 English Manual - Page 14

31. Slide a Pad Tube (21) through the hole in the 31 Seat Frame (6). Slide two Small Foam Pads (20) onto the ends of the Pad Tube. Press two 19mm Round Inner Caps (49) into the ends of the Pad Tube. Repeat this step with the other Pad Tube (21) and the Leg Lever (7). 32. Attach the Curl Pad (18) to the Curl Post (8) with 32 two M6 x 16mm Screws (59). 49 20 6 21 20 49 7 21 18 33. Wet the ends of the Lat Bar (12) with soapy 33 water. Slide the two Lat Bar Grips (33) onto the ends of the Lat Bar. 8 59 33 33 12 34. Make sure that all parts have been properly tightened. The use of all remaining parts will be explained in ADJUSTMENTS, on the next page. Before using the weight system, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly routed, they may be damaged when heavy weight is used. See the CABLE DIAGRAM on page 18 of this manual for proper cable routing. If there is any slack in the cables, you will need to remove it by tightening the cables; see TROUBLESHOOTING AND MAINTENANCE on page 19. 14