Weider Club C670 Bench English Manual - Page 15

26. Press a 50mm Square Inner Cap (13) and a 25mm Square Inner Cap (28) into the Right Butterfly Arm (56). Press two Plastic Butterfly Bushings (79) and two Metal Butterfly Bushings (113) into the Arm. Wet the bottom of the Butterfly Arm with soapy water and slide a Butterfly Foam Pad (66) onto the Arm. Lubricate a 1/2" x 78mm Bolt (97) and the Plastic Butterfly Bushings (79) with grease. Attach the Right Butterfly Arm (56) to the Butterfly Bracket (55) with the Bolt and a 1/2" Nylon Locknut (94). Cover the Bolt and Locknut with two Butterfly Caps (80). Do not overtighten the Locknut; the Butterfly Arm must be able to pivot easily. Repeat this step with the Left Butterfly Arm (57). 27. Press two Caps w/Holes (61) and two Handgrips (59) onto the Dip Arm (60). Attach the Dip Arm (60) to the Left Safety Spotter (51) with two M10 x 97mm Carriage Bolts (101) and two M10 Nylon Locknuts (34). Make sure the warning decal is in the indicated location. Note: The Dip Arm (60) can be attached to the Right Safety Spotter (not shown) in the same manner. 26 Lubricate 113 80 79 97 28 55 79 113 94 57 56 Lubricate 80 13 66 27 101 34 34 Warning Decal 60 61 59 61 59 28. Attach the Butterfly Backrest (112) to the Center Upright (45) with two M6 Washers (78) and two M6 x 75mm Screws (96). 51 28 96 78 45 96 78 112 15