Weider Club C670 Bench English Manual - Page 18
Attach the Pulley to the Weight Guide Base 41
View all Weider Club C670 Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
39. Locate the Long Cable (68). Route the eyelet 39 end of the Cable through the Foot Plate (67) and the Center Upright (45), and under a Pulley (87). Attach the Pulley (87) inside the Center Upright (45) with an M10 x 75mm Bolt (92), two M10 Washers (35), two 17mm Spacers (89), and an M10 Nylon Locknut (34). Note: The Foot Plate (67) is shown pulled away from the Center Upright for clarity. 40. Wrap the Long Cable (68) over a Pulley (87). 40 Attach the Pulley to the Double "U"-bracket (81) with an M10 x 45mm Bolt (33) and an M10 Nylon Locknut (34). 45 34 35 89 87 67 68 34 81 33 87 68 89 35 92 41. Wrap the Long Cable (68) under a Pulley (87). 41 Attach the Pulley to the Weight Guide Base (41) with an M10 x 45mm Bolt (33) and an M10 Nylon Locknut (34). 42. Wrap the Long Cable (68) over a Pulley (87). 42 Attach the Pulley and a Cable Trap (88) to the second set of holes from the bottom of the Pulley Plates (82) with an M10 x 45mm Bolt (33) and an M10 Nylon Locknut (34). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley. 43. Attach the Long Cable (68) inside the Weight 43 Guide Base (41) with an M10 x 75mm Bolt (92), two M10 Washers (35), two 28mm Spacers (91), and an M10 Nylon Locknut (34). 44. Make sure that all parts are properly tightened before the weight bench is used. The use of all remaining parts will be explained in ADJUSTMENTS, beginning on the following page. 18 68 87 34 41 33 82 33 34 87 88 68 34 68 35 91 41 91 35 92