Weider Pro 7000 Uk Manual - Page 12
Finger Guards 27, and an M10 Nylon Locknut
View all Weider Pro 7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
20. Attach a 2 3/4" Pulley (23) to the right Press Arm (8) with an M10 x 53mm Button Bolt (61), two M10 Washers (71), two 5mm Spacers (25), two Finger Guards (27), and an M10 Nylon Locknut (73). See the inset drawing. Orient the Finger Guards and Pulley as shown. Make sure the Press Arm Cable (30) is in the groove of the Pulley. 21. Make sure the Press Arm Cable (30) is routed under the indicated welded rods. Attach a "V"-pulley (22) to the Swivel Arm (16) with an M10 x 64mm Button Bolt (75), two M10 Washers (71), two 5mm Spacers (25), and an M10 Nylon Locknut (73). 22. Attach the Backrest (18) to the Upright (3) with two M6 x 25mm Screws (60) and the indicated M6 x 127mm Screw (79). 20 30 73 25 71 27 8 23 27 25 61 71 21 Welded Rods 73 71 25 16 25 75 71 30 22 22 18 27 27 23 79 60 60 3 23. Attach the Headrest (90) to the Upright (3) with 23 the two indicated M6 x 127mm Screws (79). 79 3 90 12