Weider Victory X25 Power Guide English Manual - Page 23
Pulley Cable Assembly
View all Weider Victory X25 Power Guide manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
PAGE 22 WEIDER SPORTING GOODS STEP 10 LOW PULLEY CABLE ASSEMBLY PART ' 40 5/16" FLAT WASHER 2 41 5/16" NYLON LOCK NUT 3 42 5/16" X 21/2" HEX HEAD BOLT 2 50 3/8" FLAT WASHER 2 88 1/2" O.D. X 1" LONG METAL BUSHING 1 107 5/16" X 3 1/2" HEX HEAD BOLT 1 109 5/16" X 1" HEX HEAD BOLT 1 118 5/16" THIN JAM NUT 2 K (s) u Select the LOW PULLEY CABLE (9). (This Cable has an Adjusting Ferrule and a Stopper Ball with a Loop on one end and just a Loop on the other.) NOTE: You may have to loosen or completely undo some pm-assembled Pulleys to make this assembly. u Begin at the front and LEEI side of the unit at the base of the MAIN UPRIGHT (10) with the end of the Cable with the Adjusting Ferrule and Stopper Ball and Insert the Cable into PULLEY E (36). Check to make sure that the Adjusting Ferrule and the Stopper Ball ate aligned as shown in the illustration. Tighten this assembly at this time. To trap the Cable in the Pulley, assemble a 5/16" FLAT WASHER (40) and a 1/2" O.D. X 1" LONG METAL BUSHING (88) onto a 5116" X 3 1/2" HEX HEAD BOLT (10T) and bolt through the hole location on the Main Upright dimctly below the Pulley. Assemble another 5/16" FLAT WASHER (40) onto the Bolt and secure with a 5116" NYLON LOCK NUT (41). (SEE ILLUSTRATION A) ENTIRE LOW PULLEY CABLE ROUTING 10 E 36 ADJUSTING FERRULE LOW PULLEY CABLE 40 1 LEFT 40 88 107 ILLUSTRATION A UP TO PULLEY F 9