Weider Victory X25 Power Guide English Manual - Page 24
Weider, Sporting, Goods
View all Weider Victory X25 Power Guide manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
PAGE 23 WEIDER SPORTING GOODS Remove PULLEY F (36) from the DUAL PULLEY CONNECTOR PLATE (39) assembly and fit the Pulley assembly over the loop formed in the LAT CABLE (8). Bring the LOW PULLEY CABLE (9) up from PULLEY E (36) and assemble over PULLEY F. Re-assemble PULLEY F and the Cable into the Dual Pulley Connector Plates. Tighten the Bolts tightly. (The Lat Cable and the Low Pulley Cable should be seated into the Pulleys so they can not come out.) (SEE ILLUSTRATION B) u Bring the LOW PULLEY CABLE (9) back down to the base of the MAIN UPRIGHT (10) and insert into PULLEY G (36). Position the CABLE TRAP BRACKET (37) at about the five o'clock position. Adjust the Cable Trap Bracket so it is about 1/16" from the edge of the Pulley. This assembly can now be tightened tightly. (Make sure the Pulleys can turn freely.) (SEE ILLUSTRATION C) 8 39 51 9 C 36 39 53 DOWN TO PULLEY G \ 't F UP FROM PULLEY E 36 ILLUSTRATION B DOWN FROM PULLEY F 1112 1 10 2 9 9 f% 3 8 4 7 6 PULLEY TRAP BRACKET POSITION 36 UP TO PULLEY H 1 37 ILLUSTRATION C