Weider Victory X25 Power Guide English Manual - Page 25
Pulley, Bracket, Position
View all Weider Victory X25 Power Guide manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Next, bring the CABLE (9) up the MAIN UPRIGHT (10) to the Pulley assembly at the top and back of the Upright. Assemble the Cable into PULLEY H (36) located on the side of the Pulley assembly. Position the CABLE TRAP BRACKET (37) at about the ten o'clock position and re-tighten the assembly so that the Cable Trap Bracket is about 1/16" from the edge of the Pulley. Tighten the Bolt enough so that the Cable Trap Bracket can not rotate. (SEE ILLUSTRATION D) 0 Tighten the 5/16" X 3 1/4" HEX HEAD BOLT (108) through the PULLEY PIVOT BRACKET (97) securely butnot so tight that the Bracket cannot swivelin and out. 0 Looking at ILLUSTRATION E, assemble the ARM PRESS "U" BRACKETS (110) with the pre-assembled Arm Press Pivot Brackets and Pulleys to the back of. the ARM PRESS ARMS (17). Make sure to orient the Brackets so that the "elbow" of the ARM PRESS PIVOT BRACKET (96) is to the OUTSIDE, Bolt in place by first assembling 3/8" FLAT WASHERS (50k onto two 5/16" X 2 1/2" HEX HEAD BOLT (42) and then bolting through the front of the Arm Press Arms and then into the Inside of the U-Brackets. Secure inside the U-Brackets with 5/16" NYLON LOCK NUTS (41). 108 97 CJJ 9 UP FROM PULLEY G 42 50 O frr PAGE 24 WEIDER SPORTING GOODS 10 TO 37 PULLEY J 0 9 H 36 1112 1 10 2 9 3 B 4 7 5 PULLEY TRAP BRACKET POSITION ILLUSTRATION D / 16 42 50 41 17 110 36 6 ILLUSTRATION E