Weider Viper 2000 Uk Manual - Page 16

ATTACHING THE LEG LEVER TO THE LOW PULLEY STATION To use the Leg Lever (29), the seat must be attached to the front upright (see ATTACHING AND REMOVING THE SEAT on page 15). Attach the Chain (84) between the 5/16" x 2" Eyebolt (62) on the Leg Lever (29) and the Short Cable (23) with two Cable Clips (83). ATTACHING THE LAT BAR OR NYLON STRAP TO THE HIGH PULLEY STATION Attach the Lat Bar (85) to the Long Cable (66) with a Cable Clip (83). For some exercises, the Chain (84) and/or Nylon Rope (76) should be attached between the Lat Bar and the Long Cable with two Cable Clips. If the Chain is used, adjust the length of the Chain between the Lat Bar and the Long Cable so the Lat Bar is in the correct starting position for the exercise to be performed. The Nylon Strap (39) can be attached in the same way. ATTACHING THE LAT BAR OR NYLON STRAP TO THE LOW PULLEY STATION Attach the Lat Bar (85) to the Short Cable (23) with a Cable Clip (83). For some exercises, the Chain (84) and/or Nylon Rope (76) should be attached between the Lat Bar and the Short Cable with two Cable Clips. If the Chain is used, adjust the length of the Chain between the Lat Bar and the Short Cable so the Lat Bar is in the correct starting position for the exercise to be performed. The Nylon Strap (39) can be attached in the same way. CHANGING THE STEPPING RESISTANCE To change the stepping resistance, first lift the Right and Left Pedals (89, 90) off the hooks at the lower ends of the Resistance Cylinders (91). Move the hooks to different slots under the Pedals. Make sure that the hooks are fully inserted into the slots in the same position under both Pedals. The farther the hooks are moved from the Rear Upright (82), the greater the resistance will be. CAUTION: The Resistance Cylinders become very hot during use. Allow the Resistance Cylinders to cool before touching them. 83 23 84 29 62 66 76 84 83 85 39 76 23 39 83 84 85 83 89 90 91 82 16