Weslo 750 Instruction Manual - Page 8

ARM ASSEMBLY 7 7. Apply grease to an M10 x 70mm Bolt (57). Attach the Leg Lever (9) to the Seat Frame (8) with the Bolt and an M10 Nylon Locknut (68). Do not overtighten the Locknut; the Leg Lever must be able to pivot easily. Grease 8 57 9 68 8. Apply grease to an M10 x 125mm Bolt (64). Orient the Press Frame (5) with the bracket on the side shown. Attach the Press Frame to the Top Frame (4) with the Bolt, two M10 Washers (70), and an M10 Nylon Locknut (68). Do not overtighten the Locknut; the Press Frame must be able to pivot easily. 8 64 Grease 70 5 Bracket 4 70 68 9. Apply grease to the indicated post on the Left Arm (7). Slide a 25mm x 68mm Round Bushing (28) onto the post on the Arm; make sure that the lip on the Bushing is oriented as shown. Attach an Arm Pad (20) to the Left Arm (7) with two M6 x 58mm Screws (65) and two M6 Washers (73). Repeat this step with the Right Arm (6). 9 6 8 28 Lip Post 7 20 73 65 73 26. Wrap the Low Cable (48) under a 90mm Pulley 26 (34). Attach the Pulley and two Finger Guards (35) to the bracket on the Base (1) with an M10 x 46mm Bolt (53) and an M10 Nylon Locknut (68). 27. Route the Low Cable (48) over a 90mm Pulley 27 (34). Attach the Pulley, a Cable Trap (36), and two Finger Guards (35) to the lower set of holes in the "U"-bracket (43) with an M10 x 52mm Bolt (52) and an M10 Nylon Locknut (68). Make sure that the Cable Trap is oriented to hold the Cable in the groove of the Pulley. 48 53 35 34 1 35 68 52 43 35 36 34 35 68 48 28. Route the Low Cable (48) under a 90mm Pulley 28 (34). Attach the Pulley, a Cable Trap (36), and two Finger Guards (35) to the Upright (3) with an M10 x 100mm Bolt (46), two M10 Washers (70), and an M10 Nylon Locknut (68). Make sure that the Cable Trap is oriented to hold the Cable in the groove of the Pulley. 46 35 36 34 48 70 35 3 70 68 29. Attach the Low Cable (48) to the Leg Lever (9) 29 with the M8 x 64mm Shoulder Bolt (56), an M8 Washer (71), and an M8 Nylon Locknut (69). 13 9 56 48 71 69