Weslo Pursuit E45 Bike English Manual - Page 12

MAINTENANCE AND TROUBLESHOOTING Inspect and properly tighten all parts of the exercise cycle regularly. To clean the exercise cycle, use a soft, damp cloth. To prevent damage to the console, keep liquids away from the console and keep the console out of direct sunlight. TIGHTENING THE PEDALS For best performance, regularly tighten both pedals. BATTERY REPLACEMENT If the console does not function properly, the batteries should be replaced. See assembly step 4 on page 5. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, the Left Side Shield (4) must be removed. 21 62 40 62 19 4 62 21 Using an adjustable wrench, turn the shaft of the Left Pedal (40) clockwise, and remove it from the left arm of the Crank (19). Next, remove the two M4 x 16mm Screws (21) and the five M4 x 38mm Screws (62) from the Left Side Shield (4). Move the left arm of the Crank to the position shown above, and carefully slide the Left Side Shield forward off the Crank. Next, locate the Reed Switch (18). Turn the Crank (19) until the Magnet (31) is aligned with the Reed Switch. Loosen but do not 31 21 18 19 Front View remove the M4 x 16mm Screw (21). Slide the Reed Switch slightly closer to or away from the Magnet, and then retighten the Screw. Turn the Crank for a moment. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the left side shield and the pedal. HOW TO ADJUST THE BELT The exercise cycle features a precision belt that must be kept properly adjusted. If the belt causes excessive noise or slips as you pedal, the belt should be checked. To do this, the side shields must first be removed. See the instructions at the left and remove the left side shield. Remove the right side shield in the same way. Press down on the center of 68 the Belt (68) between the front and rear pulleys. There should be 70 from 1/4" to 1" of vertical movement in the center of 56 67 the Belt. If the Belt is properly adjusted, reattach the side shields and the pedals. If the Belt needs to be adjust- ed, loosen the M8 Nylon Locknut (56) on each side of the Flywheel (70). To tighten the Belt, turn the two Adjustment Nuts (67) clockwise; to loosen the Belt, turn the Nuts counterclockwise. Make sure that the Flywheel is straight, and tighten the M8 Nylon Locknuts (56). Reattach the side shields and the pedals. PULSE SENSOR TROUBLESHOOTING • Avoid moving your hands while using the pulse sensor. Excessive movement may interfere with heart rate readings. Do not hold the metal contacts too tightly; doing so may interfere with heart rate readings. • For the most accurate heart rate reading, hold the metal contacts for about 15 seconds. • For optimal performance of the pulse sensor, keep the metal contacts clean. The contacts can be cleaned with a soft cloth-never use alcohol, abrasives, or chemicals. 12