Whirlpool EL88TRRW Installation Instructions - Page 7

5. Push the refrigerator and freezer fully into the opening. 2. Push and snap all the grille clips in place. NOTE: Make sure the grille clips are fully engaged and that the base grille's side caps are situated outside the hinge bracket on each appliance. Install the Base Grille Install the Bracket onto the Cabinets 1. Remove the plastic base grille from each appliance. 2. The four " hex head screws contained in the kit, will be used to fasten the bracket. 3. Insert one screw through the lower bracket and thread it into the cabinet. NOTE: Do not completely tighten the screw. 4. Align the bracket holes with the holes in the appliances and install the remaining three screws. NOTE: Do not completely tighten the screws. 5. Make sure the appliances are still level. Completely tighten all four bracket screws. Install the Gap Filler Assembly 1. Place the magnetic gap ller assembly between the refrigerator and freezer to ll in the gap between the appliances. NOTE: The gap ller should be ush with the tops of the appliance cabinets. Install the Bottom Grille Assembly 1. Align the four clips on the bottom grille assembly with the square holes in the base of the cabinets. Care and Cleaning Clean the trim and grille surfaces with a cotton cloth dampened with a solution of mild dish detergent and warm water. Do not use harsh or abrasive cleaners because they will damage the metal surface of the grille and trim. 7