Yamaha 407 Owner's Manual - Page 211

2 Attach two front legs and a rear leg. Refer to the diagram below to verify the orientation of the legs. Rear leg Front leg Front leg Install and tighten four 6 x 40 mm screws on each leg, starting with one of the front legs. 3 Insert the pedal cord plug into the pedal connector. Insert the plug so the arrow side faces front (toward the keyboard). If the plug will not go in easily, do not force it. Double-check the orientation of the plug, then try again. 4 Attach the cord holder on the unit as shown in the illustration below, then use the cord holder to affix the pedal cord. 3 3 Install the pedal box. 1 Remove the twist tie that affixes the pedal cord to the upper portion of the pedal box. Twist tie 4 4 Raising the unit to the standing position. Use the front legs as support to raise the unit. CAUTION • Be careful not to pinch your fingers. • When you raise the unit, do not hold the key cover. 2 Align the cord with the groove on the unit, and attach the pedal box using four 6 x 20 mm screws. Appendix CVP-409/407 Owner's Manual 211