Yamaha 407 Owner's Manual - Page 213

CVP-409/407: Keyboard Stand Assembly CAUTION • Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor- dance with the sequence given below. • Assembly should be carried out by at least two persons. • Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage. • Be sure to tighten up all screws upon completing assembly of Have a Phillips-head (+) screwdriver ready. each unit. • To disassemble, reverse the assembly sequence given below. 1 Remove all parts from the box. Confirm that all parts shown in the illustration are provided. Front leg (left) Rear leg Front leg (right) CAUTION To prevent the key cover from accidentally opening during assembly, press down on the key cover, making sure that the sheet (shown) remain in place. CAUTION • Do not place the main unit with the rear side facing down. • Do not lay the main unit upside-down on the floor. 3 Attach the front legs. Front leg (right) Incorrect Incorrect Front leg (left) 1 Fix the front right leg to the bottom surface of the unit using two screws. 2 Fix the front right leg to the speaker box using two screws. Pedal box AC power cord Bundled pedal cord inside 5x18 mm fixing screws × 14 2 With the key cover closed and the keyboard side on the bottom, lean the unit against the wall. CAUTION Please do not touch the speaker net. Doing so may damage the speaker inside. Be sure to position the keyboard side on the bottom. Spread a large soft cloth, such as a blanket, on the floor. Place the unit on the cloth with the keyboard side on the bottom and lean the unit against the wall so that the unit will not fall or slip. Place a soft cloth against the wall to protect the instrument and wall from scratches. CAUTION • Be careful not to pinch your fingers. • The top part of the music rest is not fixed. When you lean the unit against the wall, support the music rest with your hand so that the music rest will not fall. 3 Fix the front left leg in the same way. If the screw holes do not align, loosen the other screws and adjust the position of the front leg. 4 Attach the rear leg. 2 Fix the rear legs to the speaker box using two screws. 1 Fix the rear legs to the bottom surface of the unit using two screws. If the screw holes do not align, loosen the other screws and adjust the position of the rear legs. 5 Raising the unit to the standing position. Use the front legs as support to raise the unit. CAUTION • Be careful not to pinch your fingers. • When you raise the unit, do not hold the key cover. Appendix CVP-409/407 Owner's Manual 213