Yamaha 970AM Owner's Manual - Page 97
CLP-970A/970AM/970AC: Keyboard Stand Assembly
View all Yamaha 970AM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
CLP-970A/970AM/970AC: Keyboard Stand Assembly 3. Mount the main unit. CAUTION • Fingers can become pinched between the main unit and the rear or side panels, be extra careful so as not to drop the main unit. • Do not hold the keyboard in any position other than the position shown in the above illustration. Be sure to place your hands at least 10 centimeters from either end of the main unit when positioning it. 5. Connect the pedal cord. (1) Pass the pedal cord plug from the rear as shown, and insert the plug into the PEDAL jack. 6. Secure the pedal cord. (2) Use a vinyl tie to take up any slack in the pedal cord. at least 10 cm 4. Fix the main unit. (1) Center the main unit to produce equal clearance on the left and right sides. (2) Use short flat-head screws 2 to secure the main unit from the front. * Use the rear hole on the front brackets to attach the screws. (1) Attach the cord holders to the rear panel as shown, then clip the cord into the holders. 7. Set the voltage selector and connect the power cord. Voltage Selector Before connecting the AC power cord, check the setting of the voltage selector which is provided in some areas. To set the selector for 110V, 127V, 220V or 240V main voltages, use a "minus" screwdriver to rotate the selector dial so that the correct voltage for your region appears next to the pointer on the panel. The voltage selector is set at 240V when the unit is initially shipped. After the proper voltage has been selected, connect the AC power cord to the AC INLET and an AC wall outlet. A plug adaptor may be also provided in some areas to match the pin configuration of the AC wall outlets in your area. CAUTION • An improper voltage setting can cause serious damage to the Clavinova or result in improper operation. CLP-970A 97