Yamaha CS1D Owner's Manual - Page 367

Global functions Hint If you selected Multi mode in step 3, you can use MIDI channels 1-16/program changes 1-128. If you selected Single mode in step 3, you can use only program changes 1-128 of the MIDI channel that is selected by the RX CH knob. If you selected Single mode in step 3 and turned the BANK button on, you can use bank select 1-16/program changes 1-128 of the MIDI channel that is selected by the RX CH knob. In this case, the number shown in the CH column of the Program Change Event list will be the bank number. 6. Click one of the following buttons to select the type of event. 1) SCENE Scene memory recall operation 2) EFFECT Effect recall operation 3) NO ASSIGN No event assignment 7. If you selected 1) in step 6, select the number of the scene to be recalled from the list in the right side of the popup window, and click the OK button. 8. If you selected 2) in step 6, use the buttons in the lower left of the popup window to select the internal effect (1-8) that the recall operation will affect, then use the list shown at the right to select the effect library that will be recalled, and click the OK button. 9. Repeat steps 5-8 until you have assigned all the necessary events to program numbers. 10. Transmit program change (or bank select + program change) messages from the external device on the appropriate MIDI channel. The event assigned to that program number will be executed. Hint Program changes can also be transmitted from the PM1D system to an external device. To do so, connect the MIDI OUT connector of the CS1D or DSP1D-EX {DSP1D} to the MIDI IN connector of the external device, and execute the event on the CS1D that was assigned to the program number in step 9. If the same event is assigned to more than one program number, the lowest-numbered program change will be transmitted. 32