Yamaha MCR730B User Manual - Page 67
Looking after the DRX-730, Resetting the DRX-730, Installation
UPC - 027108105840
View all Yamaha MCR730B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Looking after the DRX-730 Installation • Place the DRX-730 on a stable surface close to your TV and the other AV components that you intend to use with it. • Do not place anything on top of the DRX-730. • Do not place the DRX-730 on top of your TV. And keep it away from components that are sensitive to magnetism, such as video recorders. • Do not place the DRX-730 on top of a power amplifier or any other heat producing component. If you install the DRX-730 in a rack, place the amp or other heat producing component on the bottom shelf to keep it as far away as possible from the DRX-730. Avoid locations that are... • Subject to direct sunlight • Very humid or poorly ventilated • Subject to extreme temperatures • Subject to vibration • Very dusty • Subject to smoke, steam, or hot temperatures, such as a kitchen Moving the DRX-730 Before you move the DRX-730, eject the disc if loaded, close the disc tray, and press STANDBY/ON to set it to standby. When the "STANDBY" message has disappeared, disconnect the power cable from the AC wall outlet. Note: • Disconnecting the power cable before the "STANDBY" message has disappeared may reset the DRX-730 to its factory defaults. • Moving the DRX-730 with a disc inside may cause damage. Appendix Resetting the DRX-730 You can reset the DRX-730 to its factory defaults. STANDBY/ON Play/Pause ( ɹɹ ) Stop ( ) TIMER HDMI PROGRESSIVE STANDBY/ON USB PORTABLE PHONES INPUT VOLUME 1 Set the DRX-730 to standby. 2 While holding down Stop ( ) on the DRX-730's front panel, press STANDBY/ON, keeping Stop ( ) pressed until "DVD - NO REQ." appears on the display. 3 Press Play/Pause ( / ) repeatedly to select "DVD-INIT." If you change your mind at this point, select "DVD - NO REQ." instead. 4 Press STANDBY/ON. The DRX-730 is reset to its factory defaults and goes on standby. Press STANDBY/ON again to turn the DRX-730 back on. The TV Screen, HDMI Resolution, and other settings will be set to their factory defaults. The HDMI Audio setting will be set to off. Appendix English 61 En