Yamaha MGP16X Owner's Manual - Page 24

Controls and Connectors SEND MASTER section w q GROUP/STEREO section t q SEND MASTER controls (AUX1, AUX2, FX1, FX2) These adjust the signal level sent to the AUX, AUX2, FX1 and FX2 SEND jacks. NOTE These SEND MASTER controls do not affect the level of the signal sent from the internal digital effect to the FX1 and FX2 buses. w AFL switch and indicator When the AFL (After-Fader Listen) switch is on, the indicator lights and the signal after the AUX1 and AUX2 controls (q) adjustment is output to the MONITOR OUT and PHONES jacks for monitoring. NOTE • The PFL signal has priority when both the PFL switch and AFL switch are on. To monitor the post-fader signal, make sure to turn off all PFL switches. • If the PFL (preferred) is enabled, the AFL indicator does not light, even if the AFL switch is pressed. e r y q w q GROUP 1-2 fader Adjusts the signal level to the GROUP OUT 1 and GROUP OUT 2 jacks. w GROUP 3-4 fader Adjusts the signal level to the GROUP OUT 3 and GROUP OUT 4 jacks. e ST switch If this switch is on, the signals are sent to the STEREO L/R bus via the GROUP1-2 or 3-4 fader. The Group 1 and 3 signal goes to Stereo L and the Group 2 and 4 signal goes to Stereo R. r AFL switch and indicator When the AFL (After-Fader Listen) switch is on, the indicator lights and the signal after GROUP 1-2 (q) or 3-4 (w) faders adjustment is output to the MONITOR OUT and PHONES jacks for monitoring. NOTE • The PFL switch has priority when both the PFL switch and AFL switch are on. To monitor the post-fader signal, make sure to turn off all PFL switches. • If the PFL is enabled (preferred), the AFL indicator does not light, even if the AFL switch is pressed. t ON switch Turn this switch on to enable the STEREO master fader. The switch lights when on. y STEREO master fader Adjusts the signal level sent to the STEREO OUT jacks. 24 MGP16X/MGP12X Owner's Manual