Yamaha Tio1608-D2 Tio1608-D2 Owners Manual - Page 7

English • Do not place the product in a location where it may come into contact with corrosive gases or salt air. Doing so may result in malfunction. • Before moving the product, remove all connected cables. Maintenance • Remove the power plug from the AC outlet when cleaning the product. Handling caution • Do not insert your fingers or hands in any gaps or openings on the product (vents, panel, etc.). • Do not rest your weight on the product or place heavy objects on it. NOTICE To avoid the possibility of malfunction/damage to the product, damage to data, or damage to other property, follow the notices below. Handling and maintenance • Do not use the product in the vicinity of a TV, radio, or other electric products. Otherwise, the product, TV, or radio may generate noise. • Do not expose the product to excessive dust or vibration, or extreme cold or heat, in order to prevent the possibility of panel disfiguration, unstable operation, or damage to the internal components. • Do not install in locations where temperature changes are severe. Otherwise, condensation may form on the inside or the surface of the product, causing it to break. • If there is reason to believe that condensation might have occurred, leave the product for several hours without turning on the power until the condensation has completely dried out, in order to prevent possible damage. • Do not place vinyl, plastic or rubber objects on the product, since this might cause alteration or discoloration of the panel. • Clean the product with a dry and soft cloth. Do not wipe product surfaces with sodium hypochlorite, alcohol, benzene, paint thinners, cleaning fluids, or a chemicalimpregnated wiping cloth, which could cause discoloration or change surface characteristics. Information PA_en_14 2/2 About copyrights • Copying of the software or reproduction of this manual in whole or in part by any means is expressly forbidden without the written consent of the manufacturer. Protection of copyright • Do not use this product for any purpose that may infringe upon the rights of any third party including copyrights, as established by law in each country or region. • Yamaha bears no responsibility for any infringement upon third party rights that may occur as a result of using this product. About functions/data bundled with the product • This product uses the Dante module provided by Audinate.The Dante module used in this product can be confirmed in Dante Controller. For more information about the open source licenses used for each Dante module, please visit Audinate's website. https://www.audinate.com/software-licensing • XLR-type connectors are wired as follows (IEC60268 standard): pin 1: ground, pin 2: hot (+), and pin 3: cold (-). About this manual • The illustrations and screens as shown in this manual are for instructional purposes only. • Yamaha Corporation makes no representations or warranties with regard to the use of the software and documentation and cannot be held responsible for the results of the use of this manual and the software. • The company names and product names in this manual are the trademarks or registered trademarks of their respective companies. • Software may be revised and updated without prior notice. About disposal • This product contains recyclable components. When disposing of this product, please contact the appropriate local authorities. Yamaha cannot be held responsible for damage caused by improper use or modifications to the product, or data that is lost or destroyed. - 7 - Tio1608-D2 Owner's Manual