Yamaha YAS-105 Owners Manual - Page 14

Settings Programming the sound bar with the TV's remote control (TV's remote control learning function) Once you program the sound bar, you can control it with your TV's remote control for functions such as turning on/off the TV and sound bar simultaneously, or volume up/ down and muting/unmuting of the sound bar. • This function is available only when your TV's remote control uses IR (infrared) signal. • A radio wave remote control will not work. • If by changing the volume of the sound bar the TV's volume also changes, set the TV's volume to minimum, or disable speaker output. 1 Turn off the TV. 2 Turn off the sound bar. 3 Hold down the LEARN key on the sound bar's remote control for more than 3 seconds while pointing at the appropriate remote control sensor (p.5). The sound bar enters the learning mode, and the indicators on the top panel flash as shown below. -&"3/ #-6&5005) 45"/%#: 4 Check if the appropriate remote control sensor has been activated. You can check which remote control sensor has been activated with the CLEAR VOICE indicator. CLEAR VOICE indicator Activated remote control Activated remote control sensor sensor is appropriate when... $-&"3 70*$& $-&"3 70*$& Off Lights up On the front panel On the top panel Installing the sound bar on a TV cabinet, etc. Attaching the sound bar to a wall If the appropriate remote control sensor has not been activated, press the LEARN key to exit from the learning mode, and repeat from Step 3. NOTE • Steps 5 to 8 require only the TV's remote control and the keys on the rear panel of the sound bar. The remote control of the sound bar is not necessary. • If the sound bar has already learned functions, the following indicators light up. Mute: TV Volume (-): BD/DVD Volume (+): ANALOG Power: BLUETOOTH 5 Teach the sound bar the "Mute" code of the TV's remote control. 5-1 Press (mute) on the rear panel of the sound bar. 5-2 While pointing your TV's remote control at the remote control sensor, hold down the mute key for more than 1 second twice or three times. The appropriate remote control sensor depends on the installation position (p.5). Approx. 30 cm (1 ft) TV's remote control Hold down Release Hold down (more than 1 second) (more than 1 second) (more than 1 second) Result Bleep/buzzer Indicators Successfully learned Once Lights up Failed to learn * Repeat from Twice Step 5-1. Flash Release (...) For cable or satellite set top box users: Use the original TV's IR remote control (not the cable or satellite set top box's remote control) to program the sound bar. 12 En