Yamaha YSP 1100 Owner's Manual - Page 39
Error messages for AUTO SETUP - service manual
UPC - 027108926490
View all Yamaha YSP 1100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
■ Error messages for AUTO SETUP AUTO SETUP (IntelliBeam) Before the AUTO SETUP procedure starts Error message ERROR E-2 No MIC Detected. Please check MIC connection and re-try. Cause The optimizer microphone is not connected to this unit. Remedy Connect the optimizer microphone to this unit. See page 30 While the AUTO SETUP procedure is in progress If one of the errors shown below except E-1 is displayed, press RETURN. In case you have started the AUTO SETUP procedure by pressing AUTO SETUP on the remote control in step 3, run the procedure again from step 3 after once the screen disappears. In case you have started the AUTO SETUP procedure by pressing MENU on the remote control in step 3, run the procedure again from step 4 after the screen in step 3 is displayed. Run the MANUAL SETUP if the problem is difficult to be saved. Error message Cause Remedy ERROR E-1 There is too much unwanted noise in Please test in quieter environment. your listening room. Make sure that your listening room is as quiet as possible. You may want to choose certain hours during the day when there is not much noise coming from outside. ERROR E-2 No MIC detected. Please check MIC connection and re-try. The optimizer microphone was disconnected while the AUTO SETUP procedure was in progress. Make sure that the optimizer microphone is firmly connected to this unit. ERROR E-3 Unexpected control is detected. Please re-try. Some other operations were performed on this unit while the AUTO SETUP procedure was in progress. Do not perform any other operations while the AUTO SETUP procedure is in progress. ERROR E-4 Please check MIC position. MIC should be set in front of YSP. The optimizer microphone is not placed Make sure that the optimizer microphone in front of this unit. is installed in front of this unit. ERROR E-5 Please check MIC position. MIC should be set above 1.8m/6ft. The optimizer microphone is not placed in the right distance from this unit. Make sure that the optimizer microphone is installed more than 1.8 m from the front of this unit and within 1 m from the center height of this unit. ERROR E-6 Volume level is lower than expected. Please check MIC position/connection and re-try. The optimizer microphone cannot collect the sound produced by this unit because the sound output level is too low. Make sure that the optimizer microphone is firmly connected to this unit and placed in a proper location. If the problem persists, contact the nearest YAMAHA service center for assistance. ERROR E-7 Unexpected error happened. Please re-try. An internal system error occurred. Repeat the AUTO SETUP procedure. See page - 30 - 30 30 30 - SETUP English 35 En