Zanussi Z714W43BI User Manual

Zanussi Z714W43BI Manual

Get Zanussi Z714W43BI PDF manuals and user guides View all Zanussi Z714W43BI manuals
Add to My Manuals
Save this manual to your list of manuals

Zanussi Z714W43BI manual content summary:

  • Zanussi Z714W43BI | User Manual - Page 1
    User Manual GETTING STARTED? EASY. Z714W43BI EN User Manual Washing Machine
  • Zanussi Z714W43BI | User Manual - Page 2
    above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. • Children between 3 and 8 years of age and persons
  • Zanussi Z714W43BI | User Manual - Page 3
    the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre. • Old hose sets must not be reused. • If the mains • Do not install or use a damaged appliance. • Follow the installation instructions supplied with the appliance. • Do not install or use the appliance where
  • Zanussi Z714W43BI | User Manual - Page 4
    , burns or damage to the appliance. • Follow the safety instructions on the detergent packaging. • Do not put flammable products or washing machine. • Do not touch the glass door while a programme is in operation. The glass can get hot. SERVICE • To repair the appliance contact an Authorised Service
  • Zanussi Z714W43BI | User Manual - Page 5
    THE APPLIANCE IS EQUIPPED WITH ... A BC DE x4 x2 x1 x1 x1 F G H L x1 x2 x1 x1 UNPACKING WARNING! Use the gloves. x1 x2 WARNING! Remove all the packaging and the transit bolts before installing the appliance. 1. Put two polystyrene packaging elements on the floor under the
  • Zanussi Z714W43BI | User Manual - Page 6
    hose holders and plastic spacers by using the spanner supplied with the appliance. 7. Close the holes with the plastic caps you find in the user manual bag. Put the smallest cap F in upper hole and the two bigger caps G in low- F er holes. G We recommend that you keep the packaging and
  • Zanussi Z714W43BI | User Manual - Page 7
    POSITIONING AND LEVELLING x4 1. Install the appliance on a flat hard floor. WARNING! Make sure that carpets do not stop the air circulation below the appliance. Bring the appliance near the furniture recess before levelling it. For more details, refer to paragraph "Building in". 2. Loosen or
  • Zanussi Z714W43BI | User Manual - Page 8
    from the couplings. Use the hose supplied with appliance. Do not use an extension hose if the inlet hose is too short. Contact the Authorised Service Centre for an inlet hose replacement. Water drainage The drain hose can be connected: 8
  • Zanussi Z714W43BI | User Manual - Page 9
    pipe in the room wall and L tighten it with the supplied cable tie L. You can extend the drain hose to maximum 400 cm. Contact the service centre for the other drain hose and the extension. BUILDING IN min.600 mm min. 560 mm min. 820 mm 16-22 mm This appliance
  • Zanussi Z714W43BI | User Manual - Page 10
    596 mm 553 mm 50 mm 819 mm 50 mm 140 mm 76 mm If hoses run behind the appliance, make sure that nothing closes the small recess indicated with the measures 50 x 50 mm. The appliance is also equipped with an adhesive sponge pad H that you can find inside the drum. Attach it on the top of the
  • Zanussi Z714W43BI | User Manual - Page 11
    1. Remove the screws of the top cover on the rear of the appliance and install the anti-tilting device as shown in the drawing. ~10mm 2. Adjust the anti-tilting device so that the distance from the counter is 10mm. Loosen the nut counterclockwise with a 3mm wrench. Adjust the height and turn the
  • Zanussi Z714W43BI | User Manual - Page 12
    appliance is built in completely. If the cupboard door has to be opened from left to N right, invert the position of the hinge supports M with the magnetic plate N and lower plate O. M O M N O y x y Make sure that the plate with magnet is on the upper position. Cupboard door preparation For
  • Zanussi Z714W43BI | User Manual - Page 13
    door is parallel with the appliance edge and to respect the proper opening angle (max. 105 °C). Mounting the door Fix the hinges to the hinge supports on the appliance by means of the two supplied screws B. The hinges can be adjusted to compensate for possible uneven thickness of the door. 13
  • Zanussi Z714W43BI | User Manual - Page 14
    inner side of the cupboard door, where the screw left the mark as described in the first step. 10 11 12 1 Hinge supports 2 Detergent dispenser 3 Control panel 4 Magnetic plate 5 Door handle 6 Rating plate 7 Plate with rubber beater 4 5 6 7 8 9 13 8 Drain pump filter 9 Front feet for levelling
  • Zanussi Z714W43BI | User Manual - Page 15
    CONTROL PANEL CONTROL PANEL DESCRIPTION 1 2 34 10 987 6 5 The permanent options are set by holding pressed the relative button for 3 seconds at least. 1 Programme dial 2 Display 3 Flextime touch button 4 Delay Start touch button 5 Start/Pause touch button 6 Prewash touch button and permanent
  • Zanussi Z714W43BI | User Manual - Page 16
    another one, in this case the appliance doesn't allow you to set incompatible options/ functions. FLEXTIME This option may be advisable to shorten the washing programme. Use this option for items with normal or light soil or items to refresh. Touch this button once to decrease the duration. In case
  • Zanussi Z714W43BI | User Manual - Page 17
    last rinse is not drained out to prevent the fabrics from creasing. The washing programme ends with water in the drum. The door stays locked and the after switching the appliance on. TEMP. When you select a washing programme, the appliance automatically proposes a default temperature. Touch this
  • Zanussi Z714W43BI | User Manual - Page 18
    and heavy soil. White cotton and fast-coloured cotton. Normal soil. The energy consumption decreases and the time of the washing programme is extended, ensuring good washing results. Synthetic items or mixed fabric items. Normal soil. Delicate fabrics such as acrylics, viscose and mixed fabrics
  • Zanussi Z714W43BI | User Manual - Page 19
    phase compartment of the detergent dispenser, put the flap of the compartment in upward position. Pour a cup of chlorine bleach or a washing machine cleaner in the washing phase compartment. DO NOT use both together. After the drum cleaning, run a further rinse cycle with empty drum and no detergent
  • Zanussi Z714W43BI | User Manual - Page 20
    (Type of load and soil level) Wool/Handwash 40 °C 40 °C - Cold 1200 rpm (1200 400) 1.5 kg Machine washable wool, hand washable wool and other fabrics with «hand washing» care symbol3). 1) Standard programmes for the Energy Label consumption values. According to regulation 1061/2010, these
  • Zanussi Z714W43BI | User Manual - Page 21
    Spin Prewash Delay Start Flextime Programme Spin/Drain ■ ■ ■ Rinse ■ ■ ■ ■ ■ Machine Clean ■ ■ Duvet ■ ■ ■ Daily Wash ■ ■ ■ ■ ■ ■ ■ Sport ■ ■ ■ ■ ■ ■ Denim ■ ■ ■ ■ ■ ■ Wool/Hand- ■ ■ ■ ■ wash CONSUMPTION VALUES Stated values are obtained in laboratory
  • Zanussi Z714W43BI | User Manual - Page 22
    Programmes Load (kg) Energy consumption (kWh) Water consumption (li- tre) Approximate programme duration (minutes) Remaining moisture (%)1) Cottons 40°C Synthetics 40°C Delicates 40°C Wool/Handwash 30°C 7 1.00 80 180 52 3 0.69 72 135 35 2 0.43 46 55 35 1.5 0.14 60 70 30
  • Zanussi Z714W43BI | User Manual - Page 23
    heavily oiled, greasy stains could cause damage to rubber parts of the washing machine. - Compartment for prewash phase, soak programme or stain remover. - Compartment for washing phase. - Compartment for fabric softener and other liquid treatments(fabric conditioner, starch). - Maximum level
  • Zanussi Z714W43BI | User Manual - Page 24
    that the flap does not cause a blockage when you close the drawer. SETTING A PROGRAMME 1. Turn the programme dial to select the desired washing programme. The indicator of the Start/Pause button flashes. The display shows an indicative programme duration. 2. To change the temperature and/or the
  • Zanussi Z714W43BI | User Manual - Page 25
    an alternative way of cancelling: 1. Rotate the selector knob to the "Reset" position . 2. Wait for 1 second. The display shows . Now, you can set a new washing programme. OPENING THE DOOR - ADDING GARMENTS If the temperature and level of the water in the drum are too high and/or the drum is
  • Zanussi Z714W43BI | User Manual - Page 26
    a washing bag to wash small and/or delicate items (e.g. underwired bras, belts, tights, etc. ). • A very small load can cause balance problems with the spin phase leading to excessive vibration. If this occurs: a. interrupt the programme and open the door (refer to "Daily Use" chapter); b. manually
  • Zanussi Z714W43BI | User Manual - Page 27
    use a water softener for washing machines. In areas where the water hardness is soft it is not necessary to use a water softener. To find out the water hardness in your area, contact your local water authority. Use the correct quantity of water softener. Follow the instructions that you find on the
  • Zanussi Z714W43BI | User Manual - Page 28
    washing or tap water containing iron Clean the drum with special products for stainless steel. Always follow the instructions 2. Run the Machine Clean programme. For more details, refer to washing programme table. 3. . 4. Insert the detergent drawer into the guide rails and close it. Run the rinsing
  • Zanussi Z714W43BI | User Manual - Page 29
    • The drum does not turn. • The appliance makes an unusual noise because of the blockage of the drain pump. • The display shows the alarm code . Proceed as follows to clean the pump: WARNING! • Do not remove the filter while the appliance operates. • Do not clean the pump if the water in the
  • Zanussi Z714W43BI | User Manual - Page 30
    that the impeller of the pump can rotate. If it does not rotate, contact the Authorised Service Centre. 8. Clean the filter under the water tap. 2 9. Put the filter back into the special guides by turning it clockwise. Make sure that you tighten the filter cor- 1 rectly to prevent leakages
  • Zanussi Z714W43BI | User Manual - Page 31
    . When you drain the water with the emergency drain procedure, you must activate the drain system again: 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2. Start the programme to drain the water. FROST PRECAUTIONS If the appliance is installed in an area where the
  • Zanussi Z714W43BI | User Manual - Page 32
    5. When the drain pump is empty, install the inlet hose again. TROUBLESHOOTING WARNING! Make sure that the temperature is higher than 0 °C before you find a solution to the problem (refer to the table). If the problem persists, contact the Authorised Service Centre. WARNING! Deactivate the
  • Zanussi Z714W43BI | User Manual - Page 33
    Refer to "Installation instruction". • Make sure washing programme is finished. • Set the drain or the spin programme if there is water in the drum. • Make sure that the appliance receives electrical power. • This problem may be caused by a failure of the appliance. Contact the Authorised Service
  • Zanussi Z714W43BI | User Manual - Page 34
    the detergent dispenser according the indications given in this user manual. After the check, activate the appliance. The programme continues from the point of interruption. If the problem occurs again, contact the Authorised Service Centre. If the display shows other alarm codes, deactivate and
  • Zanussi Z714W43BI | User Manual - Page 35
    tap with a 3/4'' thread. PRODUCT INFORMATION SHEET IN REFERENCE TO E.U. REGULATION 1369/2017 Trade Mark Model Rated capacity in kg Energy efficiency class Product Information Sheet ZANUSSI Z714W43BI, PNC914580206 7 A+++ 35
  • Zanussi Z714W43BI | User Manual - Page 36
    kWh Power consumption of the off-mode in W Power consumption in left-on mode in W Water consumption in litres per year, based on 220 standard washing cycles for cotton programmes at 60 °C and 40 °C at full and partial load. Actual water consumption will depend on how the appliance is used. Spin
  • Zanussi Z714W43BI | User Manual - Page 37
    Return the product to your local recycling facility or contact your municipal office. 37 *
  • Zanussi Z714W43BI | User Manual - Page 38
    38
  • Zanussi Z714W43BI | User Manual - Page 39
    39
  • Zanussi Z714W43BI | User Manual - Page 40
    157020580-B-242018 WWW.ZANUSSI.COM/SHOP
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
GETTING
STARTED?
EASY.
User Manual
Z714W43BI
EN
User Manual
Washing Machine