Zenith 615 Owner's Manual (English) - Page 22

Initial Settings (Continued) AUDIO Each DVD disc has a variety of audio output options. Set the player's AUDIO options according to the type of audio system you use. AUDIO Dolby Digital DTS MPEG Sample Freq. DRC Bitstream Bitstream PCM 48KHz Off Move Select Exit Dolby Digital / DTS / MPEG Bitstream: Select "Bitstream" if you connect the DVD Player's DIGITAL OUT jack to an amplifier or other equipment with a Dolby Digital, DTS or MPEG decoder. PCM (for Dolby Digital / MPEG): Select when connected to a two-channel digital stereo amplifier. DVDs encoded in Dolby Digital or MPEG will be automatically downmixed to two-channel PCM audio. Off (for DTS): If you select "Off", the DTS signal is not output through the DIGITAL OUT jack. Sample Freq. (Frequency) If your receiver or amplifier is NOT capable of handling 96 KHz signals, select 48 KHz. When this choice is made, this unit automatically converts any 96 KHz signals to 48 KHz so your system can decode them. If your receiver or amplifier is capable of handling 96 KHz signals, select 96 KHz. When this choice is made, this unit passes each type of signal through without any further processing. Check the documentation for your amplifier to verify its capabilities. DRC (Dynamic Range Control) With the DVD format, you can hear a program's soundtrack in the most accurate and realistic presentation possible, thanks to digital audio technology. However, you may wish to compress the dynamic range of the audio output (the difference between the loudest sounds and the quietest ones). This allows you to listen to a movie at a lower volume without losing clarity of sound. Set DRC to On for this effect. 22