Zenith SL-5610-WH-B User Guide - Page 3

TEST AND ADJUSTMENT ❒ Turn on the circuit breaker and light switch. The detector is less sensitive to motion directly towards it and more sensitive to across motion. NOTE: Sensor has a 1 1/2 minute calibration period before it will detect motion. When first turned on, wait 1 1/2 minutes. ❒ For aiming, turn the SENSITIVITY (SENS) control to the mid position and the ON-TIME control to the TEST position. Motion Motion Sensor Least Sensitive Most Sensitive ON-TIME TEST 1 5 10 MIN MAX SENS Bottom of Sensor In the test position shown above, the light will turn on for 5 seconds each time motion is detected during both daylight and darkness. Avoid aiming the control at: • Objects that change temperature rapidly, such as heating vents or air conditioners. These heat sources could cause false triggering. • Areas where pets or traffic may trigger the control. • Nearby large, light-colored objects reflecting light may trigger the shut-off feature. Do not point other lights at the sensor. 7ft (2.1 m) 110° 30 ft (9.1m) Maximum Range Maximum Coverage Angle ❒ Rotate the sensor base left and right to aim the sensor. Adjust the sensor eye up and down to obtain desired coverage range. ❒ Walk through the coverage area noting where you are when the lights turn on.Move the sensor head up, down, or sideways to change the coverage area. ❒ Set SENSITIVITY as needed. Too much sensitivity may increase false triggering. ❒ Set the amount of TIME the lights stay on after motion is detected (1, 5, or 10 minutes). Aim Sensor Down for Short Coverage Aim Sensor Higher for Long Coverage SPECIFICATIONS Range Up to 30 ft (9.1 m) [varies with surrounding temperature]. Sensing Angle Up to 110° Electrical Load Up to 60 Watt Maximum In- candescent Power Requirements. . . . 120 VAC, 60 Hz Operating Modes TEST, AUTO and MANUAL OVERRIDE Time Delay 1, 5, 10 minutes Sensitivity Adjustable HeathCo LLC reserves the right to discontinue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold. 595-5498-09