Zenith Z52DC2D Operation Manual - Page 16

HDSTB Setup - This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital signals from a digital set-top box or other digital external device, refer to the figure as shown below. - This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i). How to connect Use the TV's COMPONENT (Y, PB, PR) INPUT, RGB, HDMI/DVI jack for video connections, depending on your set-top box connector. Then, make the corresponding audio connections. Note: HDMI(High Definition Multimedia Interface): Input that accepts uncompressed digital signal and multi channel digital audio signal. How to use 1. Turn on the digital set-top box. (Refer to the owner's manual for the digital set-top box.) 2. Use INPUT on the Remote Control to select Component 1, Component 2, RGB-DTV or HDMI/DVI source. Signal Component 1/2 480i Yes 480p Yes 720p Yes 1080i Yes RGB-DTV,HDMI/DVI No Yes Yes Yes AV Out Setup The TV has a special signal output capability which allows you to hook up a second TV or monitor. Connect the second TV or monitor to the TV's AV OUT. See the Operating Manual of the second TV or monitor for further details regarding that device's input settings. Note • Component, RGB-PC/RGB-DTV, HDMI/DVI, DTV input sources cannot be used for AV out. AV IN 1 AV OUT VIDEO (L) MONO (R) (L) AUDIO (R) S-VIDEO DIGITAL AUDIO OPTICAL OUT HDMI /DVI IN S-VIDEO IN (R) AUDIO (L) VIDEO 16 DLP Projection TV