ZyXEL MES-3528 User Guide - Page 152
Advanced Application > Link Aggregation > Link Aggregation Setting
View all ZyXEL MES-3528 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
Chapter 17 Link Aggregation Table 39 Advanced Application > Link Aggregation > Link Aggregation Setting LABEL Criteria DESCRIPTION Select the outgoing traffic distribution type. Packets from the same source and/or to the same destination are sent over the same link within the trunk. By default, the Switch uses the src-dst-mac distribution type. If the Switch is behind a router, the packet's destination or source MAC address will be changed. In this case, set the Switch to distribute traffic based on its IP address to make sure port trunking can work properly. Select src-mac to distribute traffic based on the packet's source MAC address. Select dst-mac to distribute traffic based on the packet's destination MAC address. Select src-dst-mac to distribute traffic based on a combination of the packet's source and destination MAC addresses. Select src-ip to distribute traffic based on the packet's source IP address. Select dst-ip to distribute traffic based on the packet's destination IP address. Port Group Select src-dst-ip to distribute traffic based on a combination of the packet's source and destination IP addresses. This field displays the port number. Select the trunk group to which a port belongs. Apply Cancel Note: When you enable the port security feature on the Switch and configure port security settings for a port, you cannot include the port in an active trunk group. Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the nonvolatile memory when you are done configuring. Click Cancel to begin configuring this screen afresh. 152 MES-3528 User's Guide