ZyXEL MES-3528 User Guide - Page 268

Chapter 31 DHCP See Section 8.6 on page 80 for information on how to set up management IP addresses for VLANs. Figure 152 IP Application > DHCP > VLAN The following table describes the labels in this screen. Table 96 IP Application > DHCP > VLAN LABEL VID Remote DHCP Server 1 .. 3 Relay Agent Information Information DESCRIPTION Enter the ID number of the VLAN to which these DHCP settings apply. Enter the IP address of a DHCP server in dotted decimal notation. Select the Option 82 check box to have the Switch add information (slot number, port number and VLAN ID) to client DHCP requests that it relays to a DHCP server. This read-only field displays the system name you configure in the General Setup screen. Add Cancel Clear VID Type DHCP Status Select the check box for the Switch to add the system name to the client DHCP requests that it relays to a DHCP server. Click Add to save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the nonvolatile memory when you are done configuring. Click Cancel to begin configuring this screen afresh. Click this to clear the fields above. This field displays the ID number of the VLAN group to which this DHCP settings apply. This field displays the DHCP mode (Relay). For DHCP relay configuration, this field displays the first remote DHCP server IP address. 268 MES-3528 User's Guide