1996 Chevrolet Suburban Owner's Manual - Page 389

Maintenance ScheduleI - Gasoline Engines With Light Duty Emissions (Continued) 0 Check readfront axle fluid level and add fluid as needed. Check constant velocity joints and axle seals for leaking.*:$ I DATE I ACTUALMILEAGE I SERVICED BY: I 60,000 Miles (100 000 km) 0 Change engine oil and filter (or every 3 months, whichever occurs first). An Emission Control Service. 0 Lubricate the front suspension, king pin bushings, steering linkage, transmission shift linkage, transfer case shift linkage, parking brake cable guides,rear driveline centersplines, front axle propshaft splines, brake pedal springs and clutch pedal springs. Ball joints and king pin bushings should not be lubricated unless their temperature is 10" F (-12" C), or higher. When weather is cold, let the ball joints and king pin bushings warm up before lubrication or they could be damaged. Perform each of the listed lubrication service items at this mileage interval (or every 6 months, whichever occurs first). 17 Check readfront axle fluid level and add fluid as needed. Check constant velocity joints and axle seals forleaking.** 0 For 2-Wheel Drive vehicles only: Clean and repack the front wheel bearings (or at each brake relining, whichever occurs first). 0 Inspect engine accessory drive belt. A n Emission Control Service. 0 Drain, flush and refill cooling system (or every 24 months, whichever occurs first). See"Engine Coolant" in the Index for what to use. Inspect hoses. Clean radiator, condenser, pressure cap and neck. Pressure test the cooling system and pressure cap. An Emission Control Service. 0 Replace spark plugs. An Emission Control Service. (Continued) 7-26