2003 Chevrolet Venture Owner's Manual - Page 132
2003 Chevrolet Venture Manual
Page 132 highlights
Resetting the Power Sliding Door The power sliding door may operate incorrectly or not at all because of the following conditions: cle ._.,cing C,.vnwal on asteep grade (15 percent or more), the door may not stay open and could slam shut, possibly injuring someone. To make sure the door does not slam shut, turn on the power sliding door feature. Then if the door closes, it will close under the control of the power door system. VI .f your 0 A low voltage or dead battery, disconnecting the battery, or if the instrument panel PWR/HEATED SEAT PSD fuse or the underhood fuse 8, 27 or 29 are removed or blown. See Fuses and Circuit Breakers on page 5-95 for more information about your fuse panel. If any of these conditions occur, the power sliding door will need to be reset. If your vehicle has the dual power sliding doors, both doors will have to be reset. To do this: If you want to close the power sliding door(s) when the override switch(es) is turned off, pull the inside or outside handle or the edge of the door. Move the door about 4 inches (10 cm) toward the closed position and release it. The door will close completely and latch for you. To close the power sliding door(s) when the override switch(es! is turned on, pull the inside or outside handle and slide the door all the way forward to the latched position. 1. Check to be sure the power sliding door is unlocked and securely closed. 2. Turn the ignition key to OFF. 2-21