2012 Chrysler 300 Owner Manual - Page 419

STARTING AND OPERATING 417 1. Signal interference due to electronic devices or driving next to facilities emitting the same radio frequencies as the TPM sensors. 2. Installing aftermarket window tinting that contains materials that may block radio wave signals. 3. Accumulation of snow or ice around the wheels or wheel housings. 4. Using tire chains on the vehicle. 5. Using wheels/tires not equipped with TPM sensors. If the ignition switch is cycled, this sequence will repeat, providing the system fault still exists. If the system fault no longer exists, the TPM Telltale Light will no longer flash, and the ЉSERVICE TPM SYSTEMЉ message will no longer display, and a pressure value will display in place of the dashes. A system fault can occur due to any of the following: The EVIC will also display a ЉSERVICE TPM SYSTEMЉ message for a minimum of five seconds when a system fault related to an incorrect sensor location fault is detected. In this case, the ЉSERVICE TPM SYSTEMЉ message is then followed with a graphic display with pressure values still shown. This indicates that the pressure values are still being received from the TPM sensors but they may not be located in the correct vehicle 5