2012 Chrysler 300 Owner Manual - Page 54
2012 Chrysler 300 Manual
Page 54 highlights
52 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE As a guide, if you are shorter than average you will prefer a lower position, and if you are taller than average you will prefer a higher position. When you release the anchorage try to move it up and down to make sure that it is locked in position. 4. Continue to slide the latch plate up until it clears the folded webbing. Seat Belts In Passenger Seating Positions The seat belts in the passenger seating positions are equipped with Automatic Locking Retractors (ALR) In the rear seat, move toward the center of the seat to which are used to secure a child restraint system. For position the belt away from your neck. additional information, refer to "Installing Child Restraints Using The Vehicle Seat Belt" under the "Child Lap/Shoulder Belt Untwisting Procedure Use the following procedure to untwist a twisted lap/ Restraints" section. The chart below defines the type of feature for each seating position. shoulder belt. 1. Position the latch plate as close as possible to the anchor point. First Row Second Row Driver N/A ALR Center N/A ALR Passenger ALR ALR 2. At about 6 to 12 in (15 to 30 cm) above the latch plate, grasp and twist the belt webbing 180 degrees to create a • N/A - Not Applicable fold that begins immediately above the latch plate. • ALR - Automatic Locking Retractor 3. Slide the latch plate upward over the folded webbing. The folded webbing must enter the slot at the top of the latch plate.