2004 Dodge Ram 3500 Pickup Owner's Manual - Page 122

WARNING!

Your motorized door or gate will open and close

while you are training the Universal Transceiver. Do

not train the transceiver if people or pets are in the

path of the door or gate. A moving door or gate can

cause serious injury or death to people and pets or

damage to objects.

2. Position the end of your hand-held transmitter 1-3

inches (3-8 cm) away from the HomeLink buttons while

keeping the indicator light in view.

3. Simultaneously press and hold both the HomeLink

button that you want to train and the hand-held trans-

mitter buttons.

Do not release the buttons until step 4

has been completed.

NOTE:

Some gate operators and garage door openers

may require you to replace this Programming Step 3 with

procedures noted in the

²

Gate Operator/Canadian Pro-

gramming

²

section.

4. The HomeLink indicator light will flash slowly and

then rapidly after HomeLink successfully receives the

frequency signal from the hand-held transmitter. Release

both buttons after the indicator light changes from the

slow to the rapid flash.

5. Press and hold the just trained HomeLink button and

observe the indicator light. If the indicator light

stays on

constantly, programming is complete

and your device

should activate when the HomeLink button is pressed

and released.

NOTE:

To program the remaining two HomeLink but-

tons, begin with

²

Programming

²

step two. Do not repeat

step one.

122

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

2004 Dodge Ram 3500 Pickup Owner's Manual - Page 122

2004 Dodge Ram 3500 Pickup Manual

Page 122 highlights