2004 Dodge Ram 3500 Pickup Owner's Manual - Page 25

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 25 Vehicles will be shipped from the assembly plants with the park lamp flash feature activated. If desired, this feature can be disabled by using the following procedure: 1. Enter your vehicle and close all doors. 2. Fasten your seat belt (fastening the seat belt will cancel any chiming that may confuse you during this programming procedure). 3. Place the key into the ignition. 4. Turn the ignition to the ON position ( Do not start the engine ). 5. Press and hold the LOCK button on a programmed (i.e. functional) key fob. 6. Continue to hold the LOCK button, wait at least 4 seconds, but no longer than 10 seconds, then press and hold the PANIC button. 7. When a single chime is heard, release both buttons. 8. Turn the ignition to the OFF position or wait 60 seconds. 9. Test the park lamp flash feature by pressing the LOCK button on the key fob with the ignition in the OFF position or the key removed. 10. To reactivate this feature, repeat the above steps. 11. If a chime is not heard, program mode was canceled before the feature could be disabled. If necessary, repeat the above procedure. Using the Panic Alarm To activate the Panic mode while the ignition is OFF press and release the PANIC button on the transmitter once. When the Panic mode is activated, the interior lights will illuminate, the headlamps and parking lights will flash, and the horn will sound. To cancel the Panic mode press and release the PANIC button on the transmitter a second time. Panic mode will 2