2012 Dodge Charger Owner Manual SRT8 - Page 456
2012 Dodge Charger Manual
Page 456 highlights
454 WHAT TO DO IN EMERGENCIES Sealant Hose (6) to the valve stem. Check that the Mode If the sealant (white fluid) does flow through the Select Knob (5) is in the Sealant Mode position and not Sealant Hose (6): Air Mode. Press the Power Button (4) to turn On the 1. Continue to operate the pump until sealant is no TIREFIT kit. longer flowing through hose (typically takes 30 - 70 sec2. Connect the Power Plug (8) to a different 12 Volt onds). As the sealant flows through the Sealant Hose (6), power outlet in your vehicle or another vehicle, if avail- the Pressure Gauge (3) can read as high as 70 psi (5 Bar). able. Make sure the engine is running before turning ON The Pressure Gauge (3) will decrease quickly from apthe TIREFIT kit. proximately 70 psi (5 Bar) to the actual tire pressure when the Sealant Bottle (1) is empty. 3. The Sealant Bottle (1) may be empty due to previous use. Call for assistance. 2. The pump will start to inject air into the tire immediately after the Sealant Bottle (1) is empty. Continue to NOTE: If the Mode Select Knob (5) is on Air Mode and operate the pump and inflate the tire to the pressure the pump is operating, air will dispense from the Air indicated on the tire pressure label on the driver-side Pump Hose (7) only, not the Sealant Hose (6). latch pillar (recommended pressure). Check the tire pressure by looking at the Pressure Gauge (3).