1998 Ford Crown Victoria Owner's Manual - Page 55
1998 Ford Crown Victoria Manual
Page 55 highlights
Controls and features 3. Within five seconds of turning the ignition to OFF, insert the second previously programmed SecuriLock key into the ignition and turn the ignition from OFF to RUN (maintain ignition in RUN for at least one second but no more than 5 seconds). 4. Turn the ignition to OFF and remove the second SecuriLock key from the ignition. 5. Within 10 seconds of turning the ignition to OFF, insert the unprogrammed SecuriLock key (new key) into the ignition and turn the ignition from OFF to RUN (maintain ignition in RUN for at least one second). This step will program your new SecuriLock key. 6. To program additional SecuriLock key(s), repeat this procedure from step 1. If the programming procedure was successful, the new SecuriLock key(s) will start the vehicle's engine. The theft indicator (located on the instrument panel) will light for three seconds and then go out. If the programming procedure was not successful, the new SecuriLock key(s) will not operate the vehicle's engine. The theft indicator will flash on and off. Wait at least one minute and then repeat the procedure from step 1. If failure repeats, bring your vehicle to your dealership to have the spare SecuriLock key(s) programmed. KEYLESS ENTRY SYSTEM With the keyless entry keypad, you can: 1 2 3 4 5 6 7 8 9 0 • lock or unlock the vehicle doors without using the key • open trunk • disable/enable horn chirp • disable/enable autolock See also Remote entry system in this chapter for more information. Your vehicle has a factory-set 5-digit code that operates the keyless entry system. You can also program your own 5-digit personal entry code. 55