2007 Honda Odyssey Owner's Manual - Page 303

HomeLink Universal Transceiver 4. Press and hold the button on HomeLink for 3 to 4 seconds. 5. Press and hold the HomeLink button again for 3 to 4 seconds. This should turn off the training indicator on the garage door opener unit. (Some systems may require you to press the button up to three times.) 6. Press the HomeLink button again for about 1 second. It should operate the garage door. Erasing Codes To erase the codes stored in all three buttons, press and hold the two outside buttons until the red indicator begins to flash, then release the buttons. You should erase all three codes before selling the vehicle. Retraining a Button If you want to retrain a programmed button for a new device, you do not have to erase all button memory. You can replace the existing memory code using this procedure: 1. Press and hold the HomeLink button to be trained until the HomeLink indicator begins to flash slowly. If a rolling code transmitter was previously programmed, the indicator will flash rapidly for 2 seconds, and then stay on for about 23 seconds. If a standard transmitter was programmed, the indicator will stay on for about 25 seconds. 2. Once the HomeLink indicator begins to flash slowly, continue to hold the HomeLink button, and follow steps 3 thru 6 under ''Training HomeLink'' (see page 295 ). Features 297