2006 Infiniti Q45 Owner's Manual - Page 136

the right mirror position and store in the selected memory. When the driver's seat, outside mirror and steering column are not in the memorized position, the outside mirror will move with the initial tilt-down angle, if the reverse tilt-down position is stored. column and outside mirrors will move to the memorized position. 2. Turn the ignition ON. 3. Push the memory switch (1 or 2) fully for at least 1 second. The driver's seat, steering column and outside mirrors will move to the memorized position with the indicator light flashing, and then the light will stay on for approximately 5 seconds. Confirming memory storage Turn the ignition ON and push the SET switch. If the main memory has not been stored, the indicator light will come on for approximately 0.5 seconds. When the memory has stored the position, the indicator light will stay on for approximately 5 seconds. If the battery cable is disconnected, or if the fuse opens, the memory will be canceled. In such a case, reset the desired positions using the following procedures. If optional electronic keys are added to your vehicle, the memory storage procedure to switch 1 or 2 and linking electronic key procedure to a stored memory position should be performed again for each electronic key. For additional electronic key information, see "Key (Electronic ignition key)" earlier in this section. Linking an electronic key to a stored memory position An electronic key can be linked to a stored memory position with the following procedure. 1. Follow the steps for storing a memory position. 2. While the indicator light for the memory switch being set is illuminated for 5 seconds (at step 4 of storing the automatic drive positioner memory), push the "UNLOCK" button on the electronic key. The indicator light will blink. After the indicator light goes off, the electronic key is linked to that memory setting. With the key removed from the ignition switch, push the "UNLOCK" button on the electronic key. The driver's seat, steering SYSTEM OPERATION The automatic drive positioner system will not work or will stop operating under the following conditions: when the vehicle speed is above 4 MPH (7 km/h). when any two of the memory switches are simultaneously pushed while the automatic drive positioner is operating. when the adjusting switch for the driver's seat is moved while the automatic drive positioner is operating. when the memory switch (1 or 2) is not pushed for at least 1 second. when the seat has been already moved to the memorized position. Selecting the memorized position 1. Set the selector lever to the P (Park) position. 3-22 Pre-driving checks and adjustments