2008 Infiniti G37 Owner's Manual - Page 24

CAUTION ● When returning the seat to its original position, confirm the seat and seatback are locked properly. ● Be careful not to pinch your hand or foot or bump your head when operating the walk-in seat. ● While operating the walk-in seat, do not operate the seatback reclining switch. The reclining motor may be damaged. ● Do not place any objects near the seatback of the front seats. They may be pinched and damaged. The automatic forwarding and reversing will not work or stop under the following conditions: ● When the vehicle speed is above 4 MPH (7 km/h) (driver's seat only). ● When the seat belt is fastened. ● When the selector lever is not in the P (Park) position (Automatic Transmission model's driver's seat) or the parking brake is not applied (Manual Transmission model's driver's seat). ● When the door is closed (automatic forwarding only). SSS0786 Walk-in mechanism (Coupe) This feature makes it easier to get in and out of the rear seat. Use the following procedure when getting in and out of the rear seat. If the sun visor is used, close it to the original position before operating the walk-in feature. 1. Pull the seatback lever upward 1 to fold the front seatback down. Make sure that the front seatback is completely folded down. 2. To slide the front seat forward, firmly push the seatback switch 2 . The front seat will move forward. 3. Get in or out of the vehicle. 4. To return the front seat to its original position, raise the seatback and push the seatback switch 2 again. ● To stop the seat sliding, push the seatback switch 2 again or push the seat sliding switch. ● The front passenger seat will stop returning 7.0 in (177.6 mm) from its front-most position to retain space for the rear passenger. ● Depending on the seat position, the head restraint may contact the roof headlining during the walk-in operation. To prevent possible interference, lower the seat using the seat lifter switch. 1-6 Safety - Seats, seat belts and supplemental restraint system