2007 Jeep Liberty Owner's Manual - Page 119
2007 Jeep Liberty Manual
Page 119 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 119 Turn Signals Move the multi-function control lever up or down and the arrows on each side of the instrument cluster flash to show proper operation of the front and rear turn signal lights. You can signal a lane change by moving the lever partially up or down without moving beyond the detent. If either light flashes at a very fast rate, check for a defective outside light bulb. If an indicator fails to light when the lever is moved, it would suggest that the fuse or indicator is defective. NOTE: A tone will chime if the turn signals are left on for more than 2 miles (3.2 km). High Beam Switch Pull the multi-function control lever towards you to switch the headlights to HIGH beam. Pull the multifunction control lever a second time to switch the headlights to LOW beam. The "High Beam Indicator Light" will illuminate when the high beams are on. Passing Light You can signal another vehicle with your headlights by lightly pulling the multi-function control lever toward the steering wheel. This will cause the headlights to turn on at high beam and remain on until the lever is released. The "High Beam Indicator Light" will illuminate when the high beams are on. Interior Lights The overhead lights will come on when a door is opened, and when the rotating ring on the multi-function control lever is in a position other than OFF. They may also be turned on by rotating the control for the dimmer switch on the multi-function control lever fully upward or by pressing the "Unlock" button on the keyfob. The overhead lights will automatically turn off in about 8 minutes if a door is left open or the dimmer control is left in the dome light position. Turn the ignition switch ON to restore the overhead light operation. 3