2007 Jeep Liberty Owner's Manual - Page 145

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 145 Programming HomeLink NOTE: It is recommended that a new battery be placed in the hand-held transmitter of the device being programmed to HomeLink for quicker training and accurate transmission of the radio frequency signal. 1. Position the end of your hand-held transmitter 1-3 inches (5-14 cm) away from the lower left corner of the EVIC display while keeping the display in view. NOTE: Some gate operators and garage door openers may require you to replace the next step with procedures noted in the Gate Operator/Canadian Programming section. 2. Simultaneously press and hold both the desired HomeLink button and the hand-held transmitter button. After a short time, the message TRAINING will show on HomeLink display. Do not release the buttons until the next step has been completed. 3 HomeLink Buttons 3. When the message TRAINED appears on the HomeLink display, release both the HomeLink and handheld transmitter buttons. NOTE: If the HomeLink display does not change to TRAINED, contact HomeLink at www.homelink.com or call 1-800-355-3515 for assistance.