1997 Lincoln Town Car Owner's Manual - Page 99

u Remove the cover panel from your garage door u Locate the training button on the garage door opener receiver. (The receiver should be located by the garage door opener motor.) opener receiver. The exact location and color of the button may vary by garage door opener brand. If you have difficulty locating the training button, reference your garage door opener manual, or call 1-800-355-3515. opener receiver for 1-2 seconds. u Your garage door opener should now recognize your HomeLink Transmitter. You may use either your HomeLink Transmitter or your original hand-held transmitter to open your garage door. If after following these suggestions you still have difficulties in programming your HomeLink Transmitter, call toll-free for customer assistance: 1-800-355-3515. u Press the training button on the garage door u Return to the HomeLink Transmitter in the vehicle, and depress the programmed HomeLink button for the duration of the rapid flash of the HomeLink's red light, (1-2 seconds). Release the button, and re-press the button to confirm that the HomeLink Transmitter has been trained to the receiver. Erasing Channels To erase all three programmed channels, hold down the two outside buttons until the red light begins to flash. Then release both buttons. Individual channels cannot be erased, but can be reprogrammed using the procedures for programming the HomeLink Transmitter, (steps 2 through 5). NOTE: Be sure to retain your original transmitter for future programming procedures (i.e., new vehicle purchase). 95